STRIP - Alloy 430 Stainless Steel
UNS S43000
EN-DIN 1.4016
DESCRIPTION
430 stainless is a ferritic straight chrome grade. 430 presents a good corrosion resistance and formability.
Applicable Specifications
AMS 5503, ASTM A240
Applications
Appliance (components and surface), and automotive trim.
Nominal Composition
C: 0.12 max
Mn: 1.0 max
P: 0.040 max
S: 0.030 max
Si: 1.00 max
Cr: 16.0 – 18.0
Ni: 0.75 max
N: –
Fe: Balance
Physical Properties
Density:
0.28 lb./in3 (7.94 g/cm3)
Modulus of Elasticity (E):
At 70°F (20°C): 29.0 x 103 ksi
200 x 103 MPa
Coefficient of Expansion:
5.8 x 10−6 microinches/in.-°F (70-600°F)
10.4 µm/m-°C (20-300°C)
Electrical Resistivity:
23.68 µ ohm.in (60 μ ohm.cm)
Thermal Conductivity:
15.1 Btu-in./ft.2hr.-°F
26.1 W/m-K
Typical Mechanical Properties – Typical Room Temperature Mechanical Properties
Typical mechanical properties are based, AK source on ASTM A240
Annealed
- Tensile Strength (UTS): 70 ksi (483 MPa)
- 0.2% YS: 45 ksi (310 MPa)
- Elongation% in 2” (50.8 mm): 25
- Hardness Rockwell: 85 HRBW (Max)
For further information Contact:
CONTACT US
Phone: 1.888.843.2350
Elgiloy Specialty Metals – Strip Products
1565 Fleetwood Dr
Elgin, IL 60123 USA
Limitation of Liability and Disclaimer of Warranty:
- The content in these data sheets is provided primarily by third-party melting mills and is provided for reference only. It is not intended for engineering or design.
- Applications may be discussed, however, Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, does not recommend or endorse any material for any particular end use or application.
- The data included in this data sheet are typical values and may vary.
- Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, makes no representations or warranties, express or implied, as to the accuracy, completeness, condition, suitability, performance, fitness for a particular purpose, or merchantability of any information contained in any data sheet.
In no event will Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, be liable for any damages whatsoever arising from the use of the information included in the data sheets.
