STRIP - Alloy 410S Stainless Steel
UNS S41008
W.Nr 1.4000
DESCRIPTION
410S Stainless Steel is a non-hardening modification of Type 410. Small alloying additions minimize austenite formation at high temperatures, thereby restricting the alloy’s ability to harden. The result is a ductile condition when the material is rapidly cooled from above the critical temperature. This non-hardening characteristic also hinders formation of cracks when the steel is welded. The alloy is completely ferritic in the annealed condition.
Applicable Specifications
Strip and Foil:
ASTM A240
Applications
Distillation trays, Heat exchangers, Annealing boxes
Industries Supplied
Oil & Gas, Chemical Processing, General Manufacturing
Nominal Composition
C: .080 max
Mn: 1.0 max
P: 0.040 max
S: 0.030 max
Si: 1.00 max
Cr: 11.50 – 13.50
Ni: 0.60 max
Ti: 0.20 max
Fe: Balance
Physical Properties
Density:
0.280 lb/in3, (7.73 g/cm3)
Modulus of Elasticity (E):
At 70°F (20°C): 29.0 x 103 ksi (200 GPa)
Coefficient of Expansion:
6.0 µin/in-°F (32-212°F)
10.8 µm/m-°C (0-100°C)
Electrical Resistivity:
23.7 µohm-in (60 µohm-cm)
Thermal Conductivity:
187 Btu-in/ft2-hr-°F, (212°F)
26.9 W/m-K (100°C)
Typical Mechanical Properties – Typical Room Temperature Mechanical Properties
Typical mechanical properties are based on ASTM A240
Annealed
- Tensile Strength (UTS): 65 ksi (448 MPa)
- 0.2% Offset Yield: 40 ksi (276 MPa)
- Elongation in 2” (50.8 mm): 30%
- Hardness Rockwell: 75 HRBW
For further information Contact:
CONTACT US
Phone: 1.888.843.2350
Elgiloy Specialty Metals – Strip Products
1565 Fleetwood Dr
Elgin, IL 60123 USA
Limitation of Liability and Disclaimer of Warranty:
- The content in these data sheets is provided primarily by third-party melting mills and is provided for reference only. It is not intended for engineering or design.
- Applications may be discussed, however, Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, does not recommend or endorse any material for any particular end use or application.
- The data included in this data sheet are typical values and may vary.
- Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, makes no representations or warranties, express or implied, as to the accuracy, completeness, condition, suitability, performance, fitness for a particular purpose, or merchantability of any information contained in any data sheet.
In no event will Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, be liable for any damages whatsoever arising from the use of the information included in the data sheets.
