STRIP - Alloy 305 Stainless Steel
UNS S30500
EN-DIN 1.4303
DESCRIPTION
305 grade stainless has similar corrosion resistance as 304 and has good oxidation resistance in air up to 1650 F (899 C). 305 can be readily formed and deep drawn into complex shapes due to its lower strength and work hardening rate and will remain nonmagnetic after cold work unlike 301 or 304. A caution is autogenous welds in 305 are more sensitive to hot cracking than 304 or 304L.
Applicable Specifications
AMS 5514, ASTM A240
Industries Supplied
Appliances, kitchen utensils, tank covers, and other deep drawn parts.
Nominal Composition
C: .012 max
Mn: 2.0 max
P: 0.045 max
S: 0.030 max
Si: 1.00 max
Cr: 17.0 – 19.0
Ni: 10.0 – 13.0
N: 0.10 max
Fe: Balance
Physical Properties
Density:
0.29 lb./in3 (7.99 g/cm3)
Modulus of Elasticity (E):
At 70°F (20°C): 28.0 x 103 ksi in tension
193 x 103 MPa in tension
Coefficient of Expansion:
9.6 x 10−6 microinches/in.-°F (32-212°F)
17.3 µm/m-°C (0-100°C)
Electrical Resistivity:
28.4 µ ohm.in (72 μ ohm.cm)
Thermal Conductivity:
9.4 Btu-in./ft.2hr.-°F (100°C)
16.2 W/m-K (100°C)
Typical Mechanical Properties – Typical Room Temperature Mechanical Properties
Typical mechanical properties are based on AK source, ASTM A240
Annealed
- Tensile Strength (UTS): 85 ksi (586 MPa)
- 0.2% YS: 35 ksi (241 MPa)
- Elongation% in 2” (50.8 mm): 55
- Hardness Rockwell: 70 HRBW
For further information Contact:
CONTACT US
Phone: 1.888.843.2350
Elgiloy Specialty Metals – Strip Products
1565 Fleetwood Dr
Elgin, IL 60123 USA
Limitation of Liability and Disclaimer of Warranty:
- The content in these data sheets is provided primarily by third-party melting mills and is provided for reference only. It is not intended for engineering or design.
- Applications may be discussed, however, Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, does not recommend or endorse any material for any particular end use or application.
- The data included in this data sheet are typical values and may vary.
- Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, makes no representations or warranties, express or implied, as to the accuracy, completeness, condition, suitability, performance, fitness for a particular purpose, or merchantability of any information contained in any data sheet.
In no event will Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, be liable for any damages whatsoever arising from the use of the information included in the data sheets.
