- Elgiloy Specialty Metals - https://www.elgiloy.com -

Wire – L605 (Haynes 25)

Posted By Olivia Skrzypek On In | Comments Disabled
<< back to wire alloys

WIRE - L605 (Haynes® 25)

UNS R30605
W.Nr 2.4964/2.4967

DOWNLOAD PDF
GET A QUOTE

DESCRIPTION

Udimet® alloy L605 (Haynes® alloy 25) is a Cobalt-Chromium-Tungsten solid-solution strengthened alloy with excellent mechanical strength and oxidation resistance at high temperatures.  This alloy also has good fatigue resistance and galling resistance.

Applicable Specifications

Wire & Bar: AMS 5759, AMS 5796, ASTM F90, ISO 5832-5, NACE MRO175 (ISO 15156-3).

Applications

Bearings, shafts, springs and surgical fixation wire.

Industries Supplied

Medical and Aerospace.

Nominal Composition

Cr: 19 – 21
W: 14 – 16
Ni: 9 – 11
Fe: 3.0 max
Mn: 1 – 2
Co: balance
Si: 0.40 max
C: 0.05 – 0.15
P: 0.04 max
S: 0.03 max

Physical Properties

Density:
0.335 lb/in3, (9.27 g/cm3)

Modulus of Elasticity (E):
At 70°F (20°C): 32.6 x 103 ksi (225 GPa)

Coefficient of Expansion:
7.6 µin/in.-°F (70°F to 600°F)
13.6 µm/m-°C (20°C to 300°C)

Electrical Resistivity:
34.9 µΩ.in, (88.6 µΩ.cm)

Thermal Conductivity:
65.0 Btu-in/ft2hr-°F, (9.4 W/m-K)

Typical Mechanical Properties – Spring Applications

Annealed

  • Heat Treatment: 2155°F (1180°C)
  • Tensile Strength: 130 – 180 ksi; (896 – 1240 MPa)
  • Suggested Operating Conditions: -330°F to 1200°F (-200°C to 650°C)

Spring Temper

  • Tensile Strength: 220 – 280 ksi; (1517 – 1930 MPa)
  • Suggested Operating Conditions: -300°F to 1200°F (-200°C to 650°C​)

Udimet® is a registered trademark of the Special Metals Corporation group of companies, Haynes® is a registered trademark of Haynes International, Inc.

For further information Contact:

CONTACT US
Phone: 1.847.695.1900

Elgiloy Specialty Metals – Wire Products
356 N.Cross Street
Sycamore, IL 60178 USA

Limitation of Liability and Disclaimer of Warranty:

  • The content in these data sheets is provided primarily by third-party melting mills and is provided for reference only. It is not intended for engineering or design.
  • Applications may be discussed, however, Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, does not recommend or endorse any material for any particular end use or application.
  • The data included in this data sheet are typical values and may vary.
  • Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, makes no representations or warranties, express or implied, as to the accuracy, completeness, condition, suitability, performance, fitness for a particular purpose, or merchantability of any information contained in any data sheet.

In no event will Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, be liable for any damages whatsoever arising from the use of the information included in the data sheets.